Wire rope electric hoist as a lifting equipment, can be installed in the I-steel as the track of electric single beam, manual single beam, bridge, cantilever and gantry to use, with sports car wire rope electric hoist before installation need to be familiar with the installation environment, construction drawings and related precautions, so that the installation work can be orderly.

1.Installation check

The installation of electric hoist is a high-altitude operation, before installation to check whether the equipment material is in line with the specification, whether the parts are complete, and record the inspection results, carefully study the installation drawings, and understand the installation details.

2.Installation work

(1) When installing the track, the track should first be scattered under the beam, and the separate body and single beam of the electric hoist should be lifted to the appropriate position by the crane.

(2) After laying the track, it is also necessary to make the installation gear, and the gear on the track should be installed before the hoisting crane.

(3) There should be two lifting points when lifting, and the lifting points should be selected at both ends of the bridge.

(4) Lift the car, lift the electric hoist to a suitable position, and install and fix the electric hoist according to the bolt number.

3.Installation and adjustment

After installation, adjust the gap between the wheel and the track, so that the distance between the two is about 3 to 5 mm.

4.installation test

After the adjustment of the wire rope electric hoist is completed, the electric hoist is tested with no-load and dynamic and static load, so that the electric hoist can run normally.